IS 10250 : 1982 Specification for Environmental Test for Automotive Electrical Equipment

UDC 621.31 : 629.13.066 : 620.193                            TED11

Reaffirmed 2021

1 Scope

1.1 This standard specifies the basic information on degrees of severities for various environmental tests required to be conducted on automotive electrical equipment.

1.2 This standard deals only with the severities of test conditions and gives no information on electrical and mechanical checks to be made or performance requirements during or after the test, or about the expected life of the equipment. For these requirements, relevant equipment specification shall be referred.

1.3 The applicability of an environmental test and the sequence of tests shall be as given in the individual specifications.

2 References

IS 2 : 1960 Rules for rounding off numerical values

IS 269 : 1976 Specification for ordinary and low heat Portland cement

IS 2106 : Part XVI : 1971 Specification for environmental tests for electronic and electrical equipment: Part XVI Vibration test

IS 2106 : Part X : 1965 Specification for environmental tests for electronic and electrical equipment: Part X Water immersion test

IS 2106 : Part XI : 1965 Specfication for environmental tests for electronic and electrical equipment: Part XI Water spray test

IS 9000 Specification for basic environmental testing procedures for electronic and electrical items

IS 9000 : Part I : 1977 Specification for basic environmental testing procedures for electronic and electrical items

IS 9000 : Part III : Sec 1 to Sec 5 : 1977 Specification for basic environmental testing procedures for electronic and electrical items : Part III Dry heat test
Section 1 General
Section 2 Dry heat test for non-heat dissipating items with sudden change of temperature
Section 3 Dry heat test for non-heat dissipating items with gradual change of temperature
Section 4 Dry heat test for heat dissipating items with sudden change of temperature
Section 5 Dry heat test for heat dissipating items with gradual change of temperature

IS 9000 : Part II : Sec 1 to 4 : 1977 Specification for basic environmental testing procedures for electronic and electrical items : Part II Cold test
Section 1 General
Section 2 Cold test for non-heat dissipating items with sudden change of temperature
Section 3 Cold test for non-heat dissipating items with gradual change of temperature
Section 4 Cold test for heat dissipating items with gradual change of temperature

IS 9000 : Part V : Sec 1 and 2 : 1981 Specification for basic environmental testing procedures for electronic and electrical items : Part V Damp heat (cyclic) test
Section 1 16 + 8 h cycle
Section 2 12 + 12 cycle

IS 9000 : Part VII : Sec 2 : 1979 Specification for basic environmental testing procedures for electronic and electrical items: Part VII Impact test Section 2 Bump

IS 9000 : Part VIII : Sec 3 : 1979 Specification for basic environmental testing procedures for electronic and electrical items: Part VII Impact test Section 3 Drop and topple

IS 9000 : Part X : 1979 Specification for basic environmental testing procedures for electronic and electrical items : Part X Mould growth test

IS 9000 : Part XIV : 1978 Specification for basic environmental testing procedures for electronic and electrical items : Part XIV Change of temperature

This Standard has Two Amendments.

Amendment 1 and 2 is Incorporated.