Revised Standard from Last Update.

1. Scope

This standard covers the shape, dimensions and other requirements for adjusters for control cables for mopeds. The cable assembly is covered separately

2. References

The following standards contain provisions which, through reference in this text, constitute provision of this standard. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standard indicated below:

733 : 1983 Wrought aluminium and aluminium alloy bars, rods and sections (for general engineering purposes) (third revision)

742 : l981 Zinc base alloy die castings (second revision)

1573 : 1986 Electroplated coatings of zinc on iron and steel (second revision)

2062 : 2011 Hot rolled medium and high tensile structural steel (seventh revision)

2102 (Part 1) : l993/ISO 2768-1 : 1989 General tolerances: Part 1 Tolerances for linear and angular dimensions without individual tolerance indications ( third revision)

2258 : 1981 Rolled zinc plate, sheet and strip (second revision)

2500 (Part 1) : 2000/ISO 2859-1 : 1999 Sampling inspection procedures: Part 1 Attributesampling plans indexed by acceptable quality limit (AQL) for lot-by-lot inspection (third revision)

3403 : 1981 Dimensions for knurls ( first revision)

4170 : 1967 Brass rods for general engineering purposes

4218 (Part 2) : 2001/ISO 261 : 1998 ISO general purpose metric screw threads: Part 2 General plan (second revision)

4432 : 1988 Case hardening steels ( first revision)

5517 : 1993 Steels for hardening and tempering (second revision)