IS 13464 : 1992 Polyamide (nylon 66) materials for moulding and extrusion

1 Scope

This standard prescribes the requirements, methods of samplingand test for Nylon-66 materials for moulding and extrusion.

2 References

IS 196 : 1966 Atmospheric condition for testing

IS 867 : 1963 Method of test for phenolic mouldingmaterials

IS 2267 : 1972 Specification for polystyrene mouldingmaterials

IS 2824 : 1975 Method for determination ofcomparative tracking index of solid insulating materials under moist conditions

IS 2828 : 1964 Glossary of terms used in plasticindustry

IS 3396 : 1979 Method of test for volume and surfaceresistivities of solid electrical insullating materials

IS 4486 : 1967 Recommended methods for thedetermination of the permittivity and dielectric dissipation factor ofelectrical insulating materials at power, audio and radio frequenciesincluding meter wavelength

IS 4905 : 1968 Methods for random sampling

IS 5210 : 1969 High impact polystyrene sheet

IS 6746 : 1969 Unsaturated polyester resin systemsfor low pressure fibre-reinforced plastics

IS 8543 : Part 4 : Sec 1 : 1984 Plastics - Methods of testing:Part 4 Short term mechanical properties, Sec 1 Determination of tensileproperties

IS 13360 : Part 1 : 1992 Plastics - Methods of testing:Part 1 Introduction

IS 13360 : Part 6 : Sec 6 : 1992 Plastics - Methods of testing Part 6Thermal properties, Sec 6 Flammability by oxygen index

IS 13360 : Part 6 : Sec 10 : 1992 Plastics - Methods of testing:Part 6 Thermal properties, Sec 10 Determination of melting point(melting temperature or range)

IS 13360 : Part 5 : Sec 13 : 1992 Plastics - Methods of test:Part 5 Mechanical properties, Sec 13, Determination of rockwell hardness

IS 13463 : 1992 Specification for polyamide (Nylon-6)materials for moulding and extrucsion