IS 1367 : Part 14 : Sec 3 : 2018/ISO 3506-3 : 2009 Technical Supply Conditions for Threaded Steel Fasteners Part 14 Mechanical Properties of Corrosion-resistant Stainless Steel Fasteners Section 3 Set screws and similar fasteners not under tensile stress
Reaffirmed 2023
NATIONAL FOREWORD
This Indian Standard (Part 14/Sec 3) (Fourth Revision) which is identical with ISO 3506-3 : 2009 ‘Mechanical properties of corrosion-resistant stainless steel fasteners — Part 3: Set screws and similar fasteners not under tensile stress’ issued by the International Organization for Standardization (ISO) was adopted by the Bureau of Indian Standards on the recommendation of the General Engineering and Fasteners Standards Sectional Committee and approval of the Production and General Engineering Division Council.
This standard was originally published in 1961 and subsequently revised in 1967, 1984 and 2002. The Committee has now decided to adopt this standard under the dual numbering system in order to align it with the latest version of ISO 3506-3 : 2009 to make pace with the latest international practices.
This standard is published in several parts. Other parts in this series are:
Part 1 General requirements for bolts screws studs and nuts
Part 2 Tolerances for fasteners - Bolts screws studs and nuts - Product grades A, B and C
Part 3 Mechanical properties of fasteners made of carbon steel and alloy steel — Bolts screwsand studs
Part 5 Mechanical properties of fasteners made of carbon steel and alloy steel — Set screws and similar threaded fasteners with specified hardness classes — Coarse thread and fine pitch thread
Part 6 Mechanical properties of fasteners made of carbon steel and alloy steel — Nuts with specified property classes — Coarse thread and fine pitch thread
Part 7 Mechanical properties and test methods for nuts without specified proof loads
Part 8 Prevailing torque type steel nuts - Mechanical and performance properties
Part 9/Sec 1 Surface discontinuities: Section 1 Bolts screws and studs for general applications
Part 9/Sec 2 Surface discontinuities: Section 2 Bolts screws and studs for special applications
Part 10 Surface discontinuities - Nuts
Part 11 Electroplated coatings
Part 12 Phosphate coatings on threaded fasteners
Part 13 Hot-dip galvanized coatings on threaded fasteners
Part 14 Stainless steel threaded fasteners
Part 14/Sec 1 Mechanical properties of corrosion-resistant stainless steel fasteners: Section 1 Bolts, screws and studs
Part 14/Sec 2 Mechanical properties of corrosion-resistant stainless steel fasteners: Section 2 Nuts
Part 16 Designation system for fasteners
Part 17 Inspection sampling and acceptance procedure
Part 18 Packaging
Part 19 Axial load fatigue testing of bolts screws and studs
Part 20 Torsional test and minimum torques for bolts and screws with nominal diameters 1 mm to 10 mm