IS 14756 : 2024 Stainless Steel Utensils - Specification
| ICS 77.140.20; 97.040 | MED 33 |
1 SCOPE
This standard lays down the minimum requirements for following types of stainless steel utensils:
a) Cooking utensil;
b) Serving utensils;
c) Table utensils; and
d) Storage utensils.
NOTES
1 Utensils above 15 litres and 500 mm in diameter/length/width (where capacity cannot be measured), shall be classified as commercial.
2 The figures of the utensils included in this standard are for representation only.
3 Cutlery items (spoons/ladle, forks, knives) are not covered in this standard.
1.1 Applicability of Clauses
1.1.1 All clauses are applicable to cooking utensils and serving utensils (Type CS).
1.1.2 Clauses 2, 3, 4, 5, 8 and 9 (reference, materials, classification, workmanship, marking and packaging) are applicable for:
a) Serving utensils (Type S);
b) Table utensils; and
c) Storage utensils.
2 REFERENCES
The standards listed in Annex A contain provisions which, through reference in this text, constitute provisions of this standard. At the time of publication, the editions indicated were valid. All standards are subject to revision and parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of these standards.
| IS No. | Title |
| IS 5522 : 2014 | Stainless steel sheets and strips for utensils - Specification (third revision) |
| IS 6527 : 1995 | Stainless steel wire rods - Specification (first revision) |
| IS 6528 : 1995 | Stainless steel wire - Specification (first revision) |
| IS 6911 : 2017 | Stainless steel plate, sheet and strip - Specification (second revision) |
| IS 9040 : 2024 | Methods for sampling of utensils (first revision) |
| IS 9730 : 2008 | Non-stick unreinforced plastics coatings on domestic cooking utensils - specification (first revision) |
| IS 13395 : 2021 | Performance of handles and handle assemblies attached to cookware - Specification (first revision) |
| IS 15960 : 2013 | Composite bottom stainlesssteel cooking utensils - Specification |
| IS 15997 : 2012 | Low nickel austenitic stainless steel sheet and strip for utensils and kitchen appliances - Specification |
| IS 18755 : 2024 | Tri-ply (SS-Al-SS) material used for manufacture of utensils and kitchen appliances - Specification |