IS 14947 : 2001 Enamel Synthetic, Oil Resistant, Air Drying - Specification

1 Scope

1.1 This standard prescribes requirements and methods ofsampling and test for oil resistant, air drying, synthetic enamelsintended for use on metallic surfaces where transformer oilresistant property is required.

1.2 The material is suitable for use without the use of anyprimer.

2 References

IS 5 :1994Colours for ready mixed paints and enamels

IS101Methods of sampling and test for paintsvarnishes and related products:

Part 1 : Sec 1 : 1986Tests on liquid paints (general and physical),Section 1 Sampling

Part 1 : Sec 3 : 1986Tests on liquid paints (general and physical),Section 3 Preparation of panels

Part 1 : Sec 5 : 1989Tests on liquid paints (general and physical),Section 5 Flash point

Part 1 : Sec 6 : 1989Tests on liquid paints (general and physical),Section 6 Consistency

Part 1 : Sec 7 : 1987Tests on liquid paints (general and physical),Section 7 Mass per ten litres

Part 2 : Sec 1 : 1988Tests on liquid paints (chemical examination),Section 1 Water content

Part 3 : Sec 1 : 1986Tests on paint film formation,Section 1 Drying time

Part 3 : Sec 4 : 1987Tests on liquid paints (general and physical),Section 4 Finish

Part 3 : Sec 5 : 1987Tests on paint film formationSection 5 Fineness of grind

Part 4 : Sec 2 : 1989Optical test on paint films,Section 2 Colour

Part 4 : Sec 4 : 1988Optical test on paint films,Section 4 Gloss

Part 5 : Sec 1 : 1988Mechanical tests on paint films,Section 1 Hardness tests

Part 5 : Sec 3 : 1988Mechanical tests on paint films,Section 3 Impact resistance (falling weight)

Part 7 : Sec 2 : 1990Environmental tests on paint films,Section 2 Resistance to liquids

IS 335 :1993New insulating oils - Specification

IS 1070 :1992 Water for general laboratoryuse

IS 1303 :1983Glossary of terms relating to paints

IS 1407 :1980Round paint tins

IS 2552 :1989Steel drums (galvanized and ungalvanized)