IS 17017 : Part 2 : Sec 1 : 2020 Electric Vehicle Conductive Charging System - Part 2 Plugs, Socket-Outlets, Vehicle Connectors, and Vehicle Inlets - Section 1 General requirements
| ICS 29.120.30, 43.120 | ETD 51 |
1 SCOPE
This standard (Part 2/Sec 1) is applicable to plugs, socket-outlets, vehicle connectors, vehicle inlets and cable assemblies for electric vehicles, herein referred to as “accessoriesâ€, intended for use in conductive charging systems which incorporate control means, with a rated operating voltage not exceeding:
a) 690 V a.c. 50 Hz, at a rated current not exceeding 250 A; and
b) 1 500 V d.c. at a rated current not exceeding 200 A.
These accessories are intended to be installed by instructed persons or skilled persons only.
These accessories and cable assemblies are intended to be used for circuits specified in IS 17017 (Part 1) which operate at different voltages and frequencies and which may include extra-low voltage and communication signals.
These accessories and cable assemblies are to be used at an ambient temperature between -25°C and 55°C.
These accessories are intended to be connected only to cables with copper or copper-alloy conductors.
The accessories covered by this section of IS 17017 (Part 2) are for use in certain modes of charging electric vehicles. These modes are defined in IS 17017 (Part 1). These definitions and a description of the types of connection (Cases A, B and C), are described in 3.1.10, 3.1.11 and 3.1.12 of IS 17017 (Part 1):2018.
This standard (Part 2/Sec 1) does not apply to those standardized accessories used in charging systems where the use of such accessories constructed to the requirements of other standards is permitted (for example in mode 1 and mode 2). Such standardized accessories may be used for those situations (Mode and Case) identified in IS 17017 (Part 1).
This standard (Part 2/Sec 1) may be used as a guide for accessories with a lesser number of contacts and lower ratings for use with light duty vehicles.
2 REFERENCES
The standards listed below contain provisions which, through reference in this text, constitute provisions of this standard. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards listed below
IS 694 : 2010 Polyvinyl chloride insulated unsheathed and sheathed cables/cords with rigid and flexible conductor for rated voltages up to and including 450/750 V.