New Standard from Last Update.

1. Scope

This standard is applicable to vehicle couplers with pins and contact-tubes of standardized configuration, herein also referred to as “accessories”, intended for use in electric vehicle (EV) conductive charging systemswhich incorporate control means, with rated operating voltage up to 120 V DC and rated current up to 100 A.

These accessories are intended to be used for a DC interface of the conductive charging system, where the protection against electric shocks relies on electrical separation between the primary circuit and the secondary circuit of the EV supply equipment,specified in IS 17017 (Part 25).

This section of IS 17017 (Part 2) applies to accessories and cable assemblies to be used in an ambient temperature of between - 0 °C and + 5 °C.

These accessories and cable assemblies are intended to be connected only to cables with copper or copperalloy conductors.

2. References

This Clause of IS 17017 (Part 2/Sec 1) : 2020 is applicable, except as follows: Addition:

Other Publication - Title

IS/IEC 60947 (Part 3) : 2012 Low-voltage switchgear and controlgear - Part 3: Switches, disconnectors, switch-disconnectors and fuse-combination units

IS 17017 (Part 2/Sec 1) : 2020 Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 1: General requirements

IS 17017 (Part 25) : 2021 Electric vehicle conductive charging system - Part 25: DC EV supply equipment where protection relies on electrical separation