IS 17017 : Part 2 : Sec 7: 2023 Electric Vehicle Conductive Charging System Part 2 Plugs, Socket-Outlets, Vehicle Connectors and Vehicle Inlets Section 7 Dimensional Compatibility and Interchange Ability Requirements for a.c., d.c. and a.c./d.c. Pin and Contact-Tube Vehicle Couplers Intended to be used for a.c./d.c. EV Supply Equipment where Protection Relies on Electrical Separation
New Standard from Last Update.
1. SCOPE
This standard (Part 2/Sec 7) is applicable to vehicle couplers with pins and contact-tubes of standardised configuration, herein also referred to as “accessories”, intended for use in electric vehicle conductive charging systems which incorporate control means, with rated operating voltage:
a) up to 120 V d.c. and rated current up to 100 A; and
b) up to 240 V a.c. and rated current up to 32 A.
This standard (Part 2/Sec 7) applies to d.c. interfaces and combined a.c./d.c. interfaces of vehicle couplers specified in IS 17017 (Part 2/Sec 1) :2020, and intended for use in conductive charging systems for circuits specified in IS 17017 (Part 31).
This section of IS 17017 (Part 2/Sec 7) applies to the vehicle couplers to be used in an ambient temperature of between - 25 °C and + 55 °C.
These vehicle couplers are intended to be connected only to cables with copper or copper- alloy conductors.
Accessories covered by this standard shall be of non-rewireable type only.