IS 1715 : 2002 Self-Holding Tapers - Dimensions

1 Scope

1.1 This standard specifies the dimensions of Self-HoldingTapers with a small taper of about 4 to 5 percent classified,according to their use, into the three following categories:

a) Tapers for general use No. 1 to 6 morse tapers

b) Smaller tapers No. 4 and 6 metric and No. 0 morse

c) Larger tapers No. 80 to 200 metric

1.2 This Indian Standard also specifies the dimension of groovesand holes necessary for the design of tapers for applications wherecoolant supply is required.

1.3 Recommended method of measuring tolerance on tapers is givenin Annex A.

2 References

IS 2102 : Part 1 : 1993 General tolerances: Part 1 Tolerances for linear and angulardimensions without individual tolerance indications

IS 7615 : 1993 System of cone tolerances for conical workpieces. from C=1:3 to 1 : 500 and lengths from 6 to 630 mm