Revised Standard from Last Update.

1. SCOPE

This Indian Standard (Part 3) provides guidance on recommended practices for the resin socketing of wire ropes.

2. REFERENCES

The standards listed below contain provisions which, through reference in this text, constitute provisions of this standard. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards listed below. In case the standards are to be referred in this clause they are to be listed as follows:

13902 (Part 1) : 1993 Sockets for wire ropes for general purposes - Part 1 General characteristics and conditions for acceptance

13902 (Part 2) : 1993 Sockets for wire ropes for general purposes - Part 2 special requirements for sockets produced by forging or machined from the solid

13360 (Part 5/Sec 8) : 2013 Plastics - Methods of testing - Part 5 mechanical properties section 8 determination of compressive properties (first revision)

13360 (Part 6/Sec 17 ) : 2017 Plastics - Methods of testing - Part 6 thermal properties section 17 determination of temperature of deflection under load - Plastics and ebonite (second revision)

1448 : ( Part 32 ) : 2019 Methods of test for petroleum and its products [p : 32] crude petroleum and liquid or solid petroleum products - Determination of density or relative density - Capillary stoppered pyknometer and graduated bicapillary pyknometer methods (third revision)