IS 4473 : 2002 Domestic Gas Ovens for Use with Liquefied Petroleum Gases -- Specification

1 Scope

1.1 This standard specifies construction, operation, safetyrequirements and tests for domestic ovens of capacity not exceeding100 dm³, intended for use with liquefied petroleumgases at 30 gf/cm² gas inlet pressure.

Note - The capacity of the oven shall be area of the innersurface of the oven door in square decimetres multiplied by thetotal inner depth of the oven in decimetres, measured from thefront to the rear wall of the oven.

1.1.1 For convenience, this standard has been divided into threesections as follows:

Section 1 Construction

Section 2 Performance

Section 3 General

2 References

IS 292 : 1983 Leaded brass ingots and castings

IS 319 : 1989 Free cutting leaded brass bars, rods and sections

IS 410 : 1977 Cold rolled brass sheet, strip and foil

IS 1458 : 1965 Railway bronze ingots and casting

IS 3488 : 1980 Brass bars, rods and sections suitable for forging

IS 5116 : 1996 Domestic and commercial equipment for use with LPG - General requirements

IS 6480 : 1988 Glossary of terms relating to domestic and commercial gas burning appliances