ICS 77.140.50                          MTD 04

Reaffirmed 2021

1. Scope

This standard (Part 2) covers the requirements of cold reduced carbon high tensile and multi-phase steel sheets and strips for forming and where the surface is of prime importance. It covers sheets and strips up to 3.0 mm thick both in coil form and cut lengths.

2. Referenced

The following standards contain provisions which through in this text, constitute provisions of this standard. At the time of publication, the editions indicated were valid. All standards are subject to revision and parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below:

IS No. Title

228 (Relevant Parts) Method for chemical analysis for steel

1501 / Parts 1 to 4 : 2013 Metallic materials - Vickers hardness test (fourth revision)

1586 / Parts 1 to 3 : 2012 Metallic materials - Rockwell hardness test (fourth revision)

1599 : 2012 Metallic materials - Bend test (third revision)

1608 : 2005 Metallic material - Tensile testing at ambient temperature (third revision)

1956 / Part 4 : 2013 Glossary of terms relating to iron and steel: Part 4 Flat products (second revision)

8910 : 2010 General technical delivery conditions of steel and steel products

10175 : 2012 Metallic materials - Sheet and strip - Erichsen cupping test

11999 : 2007 Method for determination of plastic strain ratio ‘r’ for sheet metals

15262 : 2002 Geometrical product specifications (GPS) - Surface texture: Profile method - Terms, definitions and surface texture parameters

15756 : 2007 Metallic materials - Sheet and strip - Determination oftensile strain hardening exponent

IS/ISO 16162 : 2012 Cold-rolled steel sheet products - Dimensional and shape tolerances (first revision)