Revised Standard from Last Update.

1. SCOPE

This standard prescribes the requirements and the method of sampling and tests for grease intended for antifriction bearings, such as ball, roller and needle bearings.

2. REFERENCES

The following Indian Standards contain provisions which through reference in this text constitute the provisions of the standard. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below:

1447 (Part 1) : 2021 Methods of sampling of petroleum and its products: Part 1 Manual sampling (second revision)

1448 Methods of tests for petroleum and its products

(Part 25/Sec 1) : 2018/ISO 3104 :1994 Transparent and opaque liquids, Section 1 Determination of kinematic viscosity and calculation of dynamic viscosity (second revision)

(Part 51) : 1963 Copper strip corrosion test for lubricating greases

(Part 52) : 2017/ISO 2176 : 1995 Drop point (second revision)

(Part 53) : 1979 Determination of acidity and alkalinity of greases (first revision)

(Part 59) : 1991 Determination of mineral oil content in greases (second revision)

(Part 60) : 1994 Consistency of lubricating greases by cone penetrometer (second revision)

(Part 61) : 1974 Evaporation loss in greases 2 hour drying (first revision)

(Part 69) : 2019/ISO 2592 : 2017 Determination lash and fire points - Clevel and open cup method (second revision)

(Part 85) : 1976 Oil separation on storage of greases

(Part 89) : 1979 Test for thermal stability of lubricating greases

(Part 94) : 2019 Test for oxidation stability of lubricating grease by oxygen pressure vessel method (first revision)

(Part 164) : 2018 Determination of the leakage tendencies of automotive wheel bearing grease under accelerated conditions

(Part 165) : 2018 Test method for roll stability of lubricating grease