Revised Standard from Last Update.

1. SCOPE

1.1 This standard prescribes requirements and methods of sampling and test for ready mixed paint, finishing, air drying, for war equipment. The material is used for protection and maintenance of wooden and metal parts of war equipment, including vehicles, machine guns, bridging equipment, etc and also on POL containers as exterior petrol resisting paint.

1.1.1 The material is intended for distinctive lettering and marking, with rubber stamps of containers, packages, ammunition and ammunition packages, where quick drying is desired. The material is not intended for use on ammunition and ammunition packages containing nitrophenolic explosives.

2. REFERENCES

The standards listed below contain provisions which through reference in this text, constitute provisions of this standard. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards:

5 : 2007 Colours for ready mixed paints and enamels (sixth revision)

101 (Part 1) Methods of sampling and test for paints, varnishes and related products: Part 1 Test on liquid paints (general and physical) (third revision)

Sec 1 : 1986 Sampling (third revision)

Sec 2 : 1987 Preliminary examination and preparation of samples for testing (third revision)

Sec 3 : 1986 Preparation of panels (third revision)

Sec 5 : 1989 Consistency (third revision)

Sec 6 : 1987 Flash point (third revision)

Sec 7 : 1987 Mass per 10 litres (third revision)

Part 2 Test on liquid paints (chemical examination)

Sec 1 : 1988 Water content (third revision)

Part 3 Tests on paint film formation

Sec 1 : 1986 Drying time (third revision)

Sec 4 : 1987 Finish (third revision)

Sec 5 : 1987 Fineness of grind (third revision)

Part 4 Optical test

Sec 1 : 1988 Opacity (third revision)

Sec 2 : 1989 Colour (third revision)

Sec 3 : 1988 Light fastness test (third revision)

Sec 4 : 1988 Gloss (third revision)

Part 5 Mechanical tests

Sec 1 : 1988 Hardness test (third revision)

Sec 2 : 1988 Flexibility and adhesion (third revision)

Part 6 Durability test on paint films

Sec 1 : 1988 Resistance to humidity under conditions of condensation (third revision)

Sec 2 : 1989 Keeping properties (third revision)

Part 7 Environmental tests on paint films

Sec 2 : 1990 Resistance to liquids (third revision)

Sec 3 : 1990 Resistance to heat (third revision)

Part 8 Tests for pigments and other solids

Sec 5 : 1993 Lead restriction test (third revision)

1070 : 1992 Reagent grade water

1260 (Part 1) : 1973 Pictorial marking for handling and labelling of goods: Part 1 Dangerous goods

1303 : 1983 Glossary of terms relating to paints (second revision)

1407 :1980 Round paint tins (second revision)

1745 : 1978 Petroleum hydrocarbon solvents

2552 : 1989 Steel drums (galvanized and ungalvanized) (third revision)

13656 : 1993 Textile dyestuffs - Dispersibility of disperse dyes - Determination